Beachcomber 538 Instrucciones de operaciones descargar pdf (Pagina 7)

4. Open the air bleed thumb screws to release

any air trapped in the external plumbing.

(See Figure 4) There is one on the 300 and

500 series hot tubs, two on a 500 series with

HushPump™ and a standard 700 series and

three on a 700 series with HushPump™. See

the equipment conﬁguration diagrams on

the next page to locate the air bleed thumb

screws. Once all air is bled from the system,

open any knife valves that are facing down.

5. With the air bled from the system, you can

now turn on the power at the GFCI. Once

the control panel is on, use the instructions

on the following pages to complete your start

up. Refer to the instructions for the control

panel that matches your system.

Basic Hot Tub Conﬁgurations

Beachcomber Manufactures hot tubs in two

conﬁgurations, one of which you now own.

The Limited Edition, or Protec Hot Tub,

features the equipment outside of the hot tub

cavity under a safety step. See Figure 6.

The Original Portable features the equipment

tucked inside the hot tub cabinetry. A

plank style step is available for this style of

construction. See your dealership for details.

See Figure 7.

Beachcomber Original Portable

A plank style step is available as an optional accessory.

ﬁgure 6

ﬁgure 7

Beachcomber Limited Edition

Includes the Double Tiered Safety Step.

MICROFILTER REMOVAL AND MAINTENANCE

The Microﬁlter in the hot tub should be

cleaned approximately every two weeks or

more if bather load is high. Failure to clean the

Microﬁlter can result in cloudy water, odor and

potential equipment damage due to decreased

ﬂow. To remove the Microﬁlter, put the hot tub

on stand-by (see digital operation instructions for

your model). Stand-by prevents debris from the

Microﬁlter or objects in the water from being

sucked into the pump. Note: The hot tub will stay

in stand-by mode until the sensors detect 50ºF / 10ºC

or the temperature sensors sense a temperature more

than 20ºF / 6ºC below set point.

To remove, twist the trim ring to unlock it

and remove with the ﬂoating weir assembly,

then lift out the basket and then pull out the

Microﬁlter. See ﬁgure 8 Remove any hair or

debris from the basket. Soak the Microﬁlter

in a cleaner such as Filter Pure overnight and

then remove and rinse thoroughly with a hose

spray nozzle to remove cleaner residue. It is

recommended that you alternate Microﬁlter

cleaning each month with Filter Cure. It is also

advisable to have two Microﬁlters, to alternate

while the other is soaking in the cleaner.

ﬁgure 8

1 2 3 4 5 6 7 8 9 10 11 12 ... 31 32

Comentarios a estos manuales

Sin comentarios

Beachcomber 538 Instrucciones de operaciones Pagina 7

Comentarios a estos manuales