Beachcomber 538 Instrucciones de operaciones descargar pdf (Pagina 6)

Starting up a Beachcomber Hot Tub

Once the Protec equipment is hooked up using

the separate instructions provided with the Protec

Equipment box, and the electrical connection is

made by a qualiﬁed electrician, do the following:

1. Check all union ﬁttings on the Protec or

Portable equipment to ensure that they are

tight. Hand-tightened is sufﬁcient. If leaking

is noted at these ﬁttings you may need to

tighten further or the gasket may be missing

or not seated properly. Unscrew the union

and check.

2. Open all knife valves that are pointing up.

See ﬁgure 4. Leave all valves that are facing

down in the closed position. Fill the hot

tub with water from a garden hose. You can

hang the hose over the edge of the hot tub

or hook it up to the drain/ﬁll valve located

down by the pumps and ﬁll from the bottom.

It is recommended you run your water

through your garden hose to waste for a few

seconds before ﬁlling the hot tub.

3. Fill the hot tub to half way up the

skimmer opening. Note: If your hot tub

is HushPump™ equipped your level

can be lowered to one third up the

skimmer opening. This will allow for more

displacement if the hot tub is subjected to

use by more than the recommended amount

of people for that model. See Figure 5.

OVER FILLING WILL NOT ALLOW ROOM

FOR DISPLACEMENT FROM PEOPLE

ENTERING THE HOT TUB. UNDER FILLING COULD CAUSE AN

AIRLOCK IN THE SYSTEM AND COULD LEAD TO PUMP AND

HEATER DAMAGE NOT COVERED BY YOUR GUARANTEE.

WARNING

ENSURE YOUR HOT TUB IS SITUATED ON

A LEVEL, HARD SURFACE CAPABLE OF

SUPPORTING BOTH THE WEIGHT OF THE HOT TUB, AND THE

WATER IN IT. SEE PAGE 31 FOR DETAILS..

WARNING

ﬁgure 5

ﬁgure 4

WATER LINE

1 2 3 4 5 6 7 8 9 10 11 ... 31 32

Comentarios a estos manuales

Sin comentarios

Beachcomber 538 Instrucciones de operaciones Pagina 6

Comentarios a estos manuales